Slideshow image
   
becpl
Mfg. of Water well Drilling Rigs, Dth Hammers and Button Bits...
 
phe
Water Well Drilling Rigs, Dth Drilling Rigs, Rotary Drilling Rigs...
 
phe
Blast hole Drills, Water Well Drilling Rig, Mud Pumps, Vertical Turbine Pumps...
klrsai deepagetechjcr
 

Ditch Witch Organization Releases New Electronic Transmitter

Ditch Witch Organization

910T electronic locating transmitter

PERRY, Oklahoma — The Ditch Witch® organization announces the release of the new 910T electronic locating transmitter.
The economical Ditch Witch 910T transmitter is used to apply a controlled signal to metallic pipes and cables, and is designed to be used with the Ditch Witch 910R receiver. In active mode, the 910T transmits via direct-line connection, induction clamp or induced broadcast signals. Together, the 910R and 910T offer an affordable locator package that helps customers efficiently locate buried telephone, CATV, power, gas and water lines with a tracer wire.

910T electronic locating transmitter

The 910T transmitter comes standard with up to three frequencies of the customer’s choosing. Frequencies are factory-set when the transmitter is ordered, and additional frequencies may be added. Available frequencies are 512 Hz, 1 kHz, 8 kHz, 29 kHz, 80 kHz. With simultaneous 8 and 29 kHz transmission, an alternate signal is available if one is hard to detect. The 80 kHz frequency is helpful in locating old tracer wires or pipes with insulators where low frequencies do not work well.
Each 910T transmitter also comes standard with direct-connect leads, a ground stake and 8 D-cell batteries.

The Charles Machine Works, Inc.
Manufacturer of Ditch WitchÒ and SubsiteÒ Electronic Products
580-336-4402 · 800-654-6481 · fax 580-572-5823 · P.O. Box 66 · Perry, OK · USA  73077
www.ditchwitch.com · e-mail: info@ditchwitch.com



Drilling Today Contact