An ISO 9001 : 2008 Certified Company

Hot Products :-

Deepwell Hand Pump   |   Water Hand Pump   |   Afridev Deepwell Hand Pump

  Deep well Hand Pump IS 15500 India Mark II

The standard deep well hand pump suitable for lifting water from deep set bore holes covering static water level (SWL) ranging from 20 mtr to 40 mtrs. The pump is suitable for installation on bore well/casing size minimum dia 100 mm nominal bore size.
However with a telescopic stand assembly in place of normal stand, the same pump can be installed on a 150 mm nominal bore well size .However it is left  to  customer’s specific choice as well.

   Set of hand pump [deepwell Hand pump] assembly consists of

1. Pump head Hot Dip Galvanized

2. Handle assembly, fixed with bearings (2 Nos.)

3. Chain with coupler assembly.

4. Third plate (intermediate flange)

5. Water tank , with 32mm NB (1-1/4”) riser pipe holder

6. Connecting rod MS Electro Galvanized (10 Nos.) Option-stainless steel con. rods (10 Nos.)

7. Cylinder assembly (CI body fitted with brass liner

8. Stand assembly. normal

9. Option-telescopic stand assembly.

10. Set of Hex bolts and buts

11. Riser pipe 32mm (1.1/4) NB with socket (10)

Technical information about Deepwell Hand pump

1. Complete above ground mechanism hot dip galvanized to resist corrosion

2. Connecting rod length 3000mm (effective)

3. Riser pipe mild steel. hot dip galvanized both ends threaded one end provided with socket.

4. Cylinder. plunger & check valve parts are of Bronze cast & machined to close tolerance.

5. All rubber parts -nitrile rubber.

6. Cylinder body, top& bottom caps are of Cast Iron, Body fixed with brass liner.

Stroke Length – 125+/-4mm

Discharge Min. 15 ltrs for 40 continuous strokes per minute.



Send mail 
Home | About us | Subscribe | Advertise in Magazine | Board | Technical Papers | Interview | E-Paper | Editor's Desk | Media Kit | Directory | Contact Us | Site Map

Terms & Conditions - Disclaimer Copyright © 2009 All rights reserved.